WA combination square is a multi-purpose measuring and marking tool used in metalworking, woodworking, and stonemasonry. It is composed of a rule and one or more interchangeable heads that can be attached to the rule.
WA machinist square or engineer's square is the metalworkers' equivalent of a try square. It consists of a steel blade inserted and either welded or pinned into a heavier body at an angle of 90°. Usually a small notch is present at the inside corner of the square. This prevents small particles from accumulating at the juncture and affecting the square's reading.
WA miter square or mitre square is a hand tool used in woodworking and metalworking for marking and checking angles other than 90°. Most miter squares are for marking and checking 45° angles and its supplementary angle, 135°.
WA set square or triangle is an object used in engineering and technical drawing, with the aim of providing a straightedge at a right angle or other particular planar angle to a baseline.
WA Speed Square is a triangular carpenters' marking out tool manufactured and sold by Swanson Tool Co., Inc. The Speed Square combines common functions of the combination square, try square, and framing square into one. Carpenters use it to make basic measurements and mark lines on dimensional lumber, and as a saw guide for short 45 and 90 degree cuts.
WA square is a tool used for marking and referencing a 90° angle, though mitre squares are used for 45° angles. Squares see common use in woodworking, metalworking, construction and technical drawing. Some squares incorporate a scale for measuring distances or for calculating angles.
WThe Stanley No.1 Odd Jobs was a tool produced by the Stanley Works from 1888 to the 1930s. It combined features of sundry tools, in a single pocketable tool, including:Try square Mitre square T-square Marking gauge Mortise gauge Depth gauge Mitre level Spirit level and plumb Beam compass Inside square Ruler
WThe steel square is a tool used in carpentry. Carpenters use various tools to lay out structures that are square, many of which are made of steel, but the name steel square refers to a specific long-armed square that has additional uses for measurement, especially of various angles. Today the steel square is more commonly referred to as the framing square or carpenter's square. It consists of a long, wider arm and a shorter, narrower arm, which meet at an angle of 90 degrees. It can also be made of aluminum or polymers, which are light and resistant to rust.
WA T-square is a technical drawing instrument used by draftsmen primarily as a guide for drawing horizontal lines on a drafting table. It may also guide a set square to draw vertical or diagonal lines. Its name comes from its resemblance to the letter T. T-squares come in varying sizes, common lengths being 18 inches (460 mm), 24 inches (610 mm), 30 inches (760 mm), 36 inches (910 mm) and 42 inches (1,100 mm).
WA try square or try-square is a woodworking tool used for marking and checking 90° angles on pieces of wood. Though woodworkers use many different types of square, the try square is considered one of the essential tools for woodworking.