Appliance plugW
Appliance plug

An appliance plug is a three-conductor power connector originally developed for kettles, toasters and similar small appliances. It was common in the United Kingdom, New Zealand, Australia, Germany, the Netherlands and Sweden.

C connectorW
C connector

The C connector is a type of RF connector used for terminating coaxial cable. The interface specifications for the C and many other connectors are referenced in MIL-STD-348. The connector uses two-stud bayonet-type locks. The C connector was invented by Amphenol engineer Carl Concelman. It is weatherproof without being overly bulky. The mating arrangement is similar to that of the BNC connector. It can be used up to 11 Ghz, and is rated for up to 1500 volts.

FME connectorW
FME connector

FME is a miniature 50Ω RF connector series offering excellent performance from DC to 2000 MHz used primarily with RG-58 or equivalent coaxial cables employed in mobile applications and installations.

GR connectorW
GR connector

The GR connector, officially the General Radio Type 874, was a type of RF connector used for connecting coaxial cable. Designed by Eduard Karplus, Harold M. Wilson and William R. Thurston at General Radio Corporation. It was widely used on General Radio's electronic test equipment and some Tektronix instruments from the 1950s to the 1970s.

MCX connectorW
MCX connector

MCX are coaxial RF connectors developed in the 1980s. They have the same inner contact and insulator dimensions as the SMB connector but are 30% smaller. MCX is standardized in European CECC 22220.

MHV connectorW
MHV connector

The MHV connector is a type of RF connector used for terminating coaxial cable.

MMCX connectorW
MMCX connector

Micro-miniature coaxial (MMCX) connectors are coaxial RF connectors similar to MCX but smaller. They conform to the European CECC 22000 specification. MMCX connectors are rated to 500 pairing cycles.

Motorola connectorW
Motorola connector

A Motorola connector also known as a motorola antenna plug, a male DIN 41585, or simply a DIN connector, is a common coaxial cable RF connector used primarily in the automotive industry for connecting the coaxial feedline from the antenna to the radio receiver. It is also sometimes used for connecting scanner antennas to scanners. The male plug somewhat resembles an RCA connector in size and shape, but instead of surrounding the pin, the sleeve is "folded" back over the coax.

SMB connectorW
SMB connector

SMB connectors are coaxial RF connectors developed in the 1960s. SMB connectors are smaller than SMA connectors.

SMC connectorW
SMC connector

SMC connectors are coaxial RF connectors developed in the 1960s. The interface specifications for the SMC and many other connectors are referenced in MIL-STD-348. They use a #10-32 UNF threaded interface. They offer electrical performance from DC to 10 GHz. Male SMC connectors have a socket for the center contact, and Female SMC connectors have a pin for the center contact. SMC jack connectors have an external thread while SMC plug connectors have the mating hex nut. Available in 50-Ohm and 75-Ohm characteristic impedance, they provide an interconnect means for small form factor coaxial cables and printed circuit boards where small footprint is important.

Tee connectorW
Tee connector

A tee connector is an electrical connector that connects three cables together. It is usually in the shape of a capital T. It is usually used for coax cables and the three connector points can be either female or male gender, and could be different or the same standard, such as F type, BNC or N type.